AS119 MicroCare Snore Stopper

Item #: AS119

MicroCare Snore Stopper - Immediate Snore Relief for Yourself and Your Sleeping Partner

Nearly half of the population is affected by snoring (or by their sleeping partners). Snoring most commonly occurs when persons sleep on their back, or remain unchanged positions throughout the night. A change of sleeping position can often stop a person snoring.

MicroCare Snore Stopper is designed like a watch with an adjustable Velcro strap. There are no sharp edges, which can harm person or his/her partner while asleep, or which can get caught up in bed linen.

Simply put on MicroCare Snore Stopper before going to sleep and press the button to activate.

MicroCare Snore Stopper works by detecting snore sounds and sending out weak electrical impulses to the wrist, which will normally cause the person to move and change sleeping positions without waking up. The MicroCare Snore Stopper is completely painless.

Technical Data:

• Model No AH 5217

• Power Source: Lithium Battery Type CR2032 3 Volts

• Complies to: EN 61000-6-1:2001, EN 61000-6-3:2001

• Conforms to: EMC Regulations (Electrode Magnetic Compatibility Directive 89/336 EEC)

ISO 9002 Certified

Battery Replacement: Snore Stopper uses model CR2032 3 volt Lithium battery Batteries can be obtained from most drug stores.

Caution:

-De not use or place unit near any open flames. (Any form of fire or candles, etc.)

-Do not immerse unit in water i.e. do not use in bath or while washing hands. In the event that MicroCare Snore Stopper is not used for a long period of time, remove the battery from the battery compartment to ensure there is no corrosion.

Note: More information is available in the User’s Guide. Please see product for more details. 

Instructions for Use:

1. Remove battery compartment, which is located underneath the unit.

2. Insert CR2032 Lithium battery provided with printed surface on the battery facing upwards.

3. Close battery compartment.

4. Apply coat of contact gel to each black electrode situated underneath Snore Stopper.

5. Place on either wrist using comfortable Velcro strap. Adjust strap so it is firmly, but comfortably attached - strap should not feel in any way tight.

6. Press "Power Start" and hold down until green LED flashes. You will feel the electronic impulses, which are transmitted to your wrist via the electrodes. The electronic impulses are memorized at the previous intensity level setting. Press "Max" or "Min" button to adjust intensity so you can feel at a comfortable level. Remember that the idea of the Snore Stopper is that these impulses will be enough to make you change sleeping positions but not to wake you up!

7. Press "Power Start" to confirm intensity level selected.

8. Test unit by making a "snoring sound". You will feel impulses are activated for about three seconds and green LED light will flash. Unit will then deactivate until such time as it hears a further "snoring sound".

9. To turn off unit, keep "Power Start" depressed until red LED flashes.

10. To reset or change the intensity level, press "Power Start" and keep depressed until green LED flashes. Then follow steps 5 to 7 again.

11. Unit will automatically switch off after 8 hours.

12. After use, wipe away all surface contact gel from back of unit using a piece of cloth or tissue.